Please call Tech Support to verify your particular needs before ordering a Clipper from the Turbine Matrix as each system is different.
The MidNite Clipper is designed to control Wind or Hydro turbines and work with the Classic to charge your battery. The Clipper communicates with the Classics to slow the turbine when the batteries are full, and also contains a stand alone self powered adjustable max VOC limiting circuit. The AC Clipper is designed to work with AC turbines and was designed for up to 1.5kw maximum turbines. The 1.5K AC Clipper comes standard with 2 ohms of resistance per phase. We can custom build other resistance values upon request and have designed an easy to change resistor insert for the Clipper allowing changes in the field.
The AC Clipper contains two 277 VAC 50 Amp 3 phase AC breakers (one for a stop switch) and a 1200 volt 200 Amp 3 phase bridge rectifier.
AVAILABLE IN THE FOLLOWING MODEL NUMBERS:
The 1,500 watt AC Clipper comes in several different resistance values. The standard values available are 0.8 and 2.0 ohms per phase. Please add the value to the part number (For Example MNCLIP1.5KAC2.0) Please contact Customer service for help picking the correct resistance or if you need a value not listed.Turbine Matrix for the Clipper
Clipper Installation video at Rick's
Clipper Installation video at Tim's
Warranty - 5 yrs.
Made in the USA
California Residents: Warning
The Classic 150 MPPT Charge Controller - Listed by ETL for US & Canada CE Certified FCC Class B
The Classic 200 MPPT Charge Controller - Listed by ETL for US & Canada CE Certified FCC Class B
The Classic 250 MPPT Charge Controller - Listed by ETL for US & Canada CE Certified FCC Class B
The MidNite Solar 300V AC Surge Protector Device (MNSPD) is a Type 1 device per UL1449 rev3 and has an outdoor rating of 4X for outdoor use. Protection for 120 VAC and 120/240 VAC circuits.
The MidNite Solar 300V Surge Protector Device (MNSPD) is a Type 1 device per UL1449 rev3 and has an outdoor rating of 4X for outdoor use. Protection for Classic and other charge controllers, off grid PV combiners and 120/240 VAC circuits.
5, 10, 15, 20, 30, 40, 50, 60, 70, 80, 90, 100 amp 150VDC Panel Mount. 10,000 AIC
Nipple Kit - One inch close nipple, three one inch lock nuts and two insulating bushings.
CHARGE CONTROL BRACKETS - Right/Left - Right or left hand charge control brackets. Fits OutBack, Xantrex and MidNite MPPT controllers.